Measurements become useful when you know what they represent. Prepare better decisions about electricity use, lighting and connected controls.
Editorial team: Elektro Barin2 min readPublished:
Separate power from energy use
Watts describe electrical power; kilowatt-hours describe energy used over time. A constant 100 watts for ten hours works out to one kilowatt-hour. This is an arithmetic example, not a forecast for a particular appliance. Where power changes during use, one momentary reading cannot establish a reliable annual total.[1]
Decide what the number should tell you
Are you considering the whole household, one appliance or the effect of a changed routine? Write down the question before measuring. Also record the period, unit and area covered. Two readings say little if one covers the whole home while the other covers only a desk.
Which appliances or rooms does this figure include?
Was it measured, estimated or copied from a specification?
Was the household used in a similar way during the comparison period?
Do not turn one observation into a conclusion
The German consumer advice organisation Verbraucherzentrale identifies energy meters as a way to assess individual appliances. Energy-label information can also help with comparisons. Keep your measurements separate from standardised product figures. When a value looks unusual, first discuss how it was obtained rather than immediately buying a new appliance or automation system.[2]
Turn observations into a clear brief
Describe the desired outcome: understandable consumption information, for example, or lighting controls that suit the room's use. Identify which information is missing and which functions you actually need. Have work on fixed electrical installations assessed by an electrical specialist; this initial review does not require opening covers or fitting sensors inside a distribution board yourself. A new display alone cannot guarantee savings.
What should become clearer or easier to operate?
How will you check whether the change helped?
Which controls, data access and documents belong in the handover?